MosChip, IdealBT team up for NAS apps
The technology partnership leverages MosChip's SoC network appliance processors and IdealBT's embedded Linux-based software. Both technologies are already in use in various network attached storage applications, but the integrated solution is expected to reduce time to market and costs.
ARC details restructuring plan
ARC will lay off 35 employees and shut down several of its locations as part of a major restructuring plan.
- Tokai U's solar car fuelled by Sharp
- PV testing facility opens in China
- IBM re-uses PV energy for improved efficiency
- NAND vendors begin scaling race
- More players enter MEMS foundry market
- Nokia Intel tie-up highlights convergence
- India VCs shift investments on cleantech, biotech
eInfochips rolls four VMM-enabled VIP products
eInfochips announced the availability of VMM-enabled MIPI CSI-2, DSI, HSI & SDIO verification IP.
best power supply topology?
Ram Anant says, "One can suggest the most appropriate topology once we know the Vin, Vout, Iout, isolation required or not and application (Load)"
• FPGA Xilinx cabling problem
• MCU or FPGA?
• Schematic proposal
• Be responsible.. Recycle electronics
• India: Reaching its full potential
• Can't wait for a new batt tech
• Defects blamed on lack of renewables
• cloud standards
more topics...
Differential amplifier
Learn about differential amplifiers as a basic building block of analogue ICs. This video lecture is conducted by Prof. K. Radhakrishna Rao from Department of Electrical Engineering, IIT Madras.
Open The File June 16 issue about the latest breakthroughs in medical electronics, such as computer-aided detection, telemedicine, and more. Read these articles now!
• MCUs enable disposable medical instruments
• Automating disease detection
• RPM to transform healthcare landscape
• Electronics realises healthcare dream
Electronics future in conventional films
The U.S. Department of Energy's Oak Ridge National Laboratory demonstrated ferroelectric memory switches.
- Graphene to enable tunable electronic devices
- New study shows way to stretchable electronics
- SiGe terahertz RFICs provide X-ray-like vision
Secure nextgen VoIP phones with 802.1x
Know the value of 802.1x standard in authenticating and authorising physical connections to a network.
- Advantages of 1394 Automotive network
- Probe, calibrate for accurate BBIQ measurements
- Design implantable antenna for medical devices
Learn how over-the-air testing can reveal major antenna performance differences between GPS devices.
- Understanding WiMAX protocol testing
- Enabling mobile phones on high seas
- Implement rural public transport scheduling
Displays enable situation-based info systems
Read about the latest trends in automotive display, especially LED backlighting which has better starting properties than CCFL.
- Reduce eyestrain with LED soft-start
- Address image capture, processing challenges in portables, Part 4
- Address image capture, processing challenges in portables, Part 3
Test GPS receivers with real-world data
Know the benefits of testing GPS receivers with recorded signals over traditional simulation or drive testing approaches.
- Challenges for WiMedia compliance test
- Test wireless devices for HSUPA compatibility
- Complying with PCI Express
nvSRAMs for charging flash in data-loggers
Learn how to resolve the challenges memory sub-systems where flash is the only nonvolatile memory.
- Advantages of higher-density SRAMs
- Improve embedded systems performance with DRAM
- Antifuse memory IP offers low-power operation
India centre designs Freescale MCUs
The Kirin3 family of MCUs is an important milestone in Freescale India's design accomplishments.
ABI: 366k picocells deployed by 2013
The "big brothers" of femtocells are forecast to grow at a compound annual growth of 38 per cent since 2008.
- Analyst: SuperSpeed USB 10x faster
- DisplaySearch says LCD TVs looking up
- Indian mobile services market to hit $30bn
Powerline comms for nextgen home networking
Powerline communications enable a broadband connection to be sent using the existing electrical wiring available in every room.
- Opportunity to win on different design fronts
- The real score in portable power specs
- Program current limiter via resistor
Hardware design needs hardware design languages
Read about the experiences in RTL market that are applicable to ESL.
- Incremental DRC for chip verification
- Complex SoCs power intent verification
- IC verification: Coverage vs. qualification
Control analogue output from CPLD with PWM
Know how CPLD can replace DAC, allowing it to drive an audio speaker or control things like LED intensity.
- Close timing on high-speed ADCs
- Audio signal chain design for non-audio experts
- Effect of clock jitter on high-speed ADCs, Part 2
Implement ATCA in LTE SGW nodes
Read about the "best practices" approach for building an ATCA Serving Gateway node.
- Why you need Ethernet timestamps
- Cut packet loss in wireless USB apps
- Intro to synchronised Ethernet
Interface to audio ADC sampling ICs
Know how to effectively interface to A/D converter sampling networks to ensure a successful design.
- Bandwidth relief in PCI Express systems
- Take advantage of GPIB capabilities
- HDMI design guide for high-speed PCB design
Know the advantages of surface-mounted device packages over through hole ones for power MOSFETs.
- RoHS: Its impact now and in the future
- Address power during manufacturing test
- Understand screen printing, component placement
Open The File June 16 issue about the latest breakthroughs in medical electronics, such as computer-aided detection, telemedicine, and more!
The File on Green Power
• Choosing a Primary Battery for a Wireless Device Download now! 
• Actionable Enterprise Architecture Management Download now!
Lessons in time, cost savings from iPhone 3GS
A more integrated—and probably lower cost—iPhone caused one analyst to quip the 'S' in 3GS may stand for savings.
Diagnose transducers with smart SoC
Use the MAXQ7667 to diagnose the resonant frequency and damping characteristics of an ultrasonic transducer.
- CCFL power supply for auto displays
- Hamming codes for NAND flash
- Guide to spacing of CAN bus connections
- TS612 as driver for ADSL line interfaces
 | ||||
| India all set for LCD panel manufacturingnew! | ||||
| sesh67 says: "India should directly jump to LED panel manufacturing instead of LCD panels for low power green/cleantech push." reply | ||||
|
||||
Catch up on last week's most viewed articles!
- Switch mode power supply topologies, Part 2
- Exposing the surprises inside Palm Pre
- Embedded design needs power-awareness
- Cadence to layoff 225 employees
- HDMI challengers to create new class of home nets
- Techniques for EMI, safety in power supplies
- Semiconductor market to fall by 21.6%
- Market for LEDs in notebooks lights up
- Flexible memory chip developed
- Sensorless FOC of an AC induction motor
While the doctor's job is the safest today, acquiring new skills can help design engineers get a slice with products for this market.
The overall effect of the tooling up process is to distract you from the real aim of the project.
By Rob Irwin
RPM to transform healthcare landscape
Read about remote patient monitoring and how it can help improve the global healthcare scenario.
There will always be artists and there will always be engineers. In troubling times, passion counts more than ever.
By Jack Ganssle
India: The next Silicon Valley?
While the original Silicon Valley maybe losing its sparkle, the new Indian contenders are very likely to shine out of the current global recession.
By Nitin Dahad
Freescale exec tackles future of automotive
Steve Wainwright: The market and the technology definitively will be different when the automotive market does recover.
The problem with massively parallel chips
Companies that make massively parallel chips and tools will have to grapple with "stickier" software.
By Jeff Bier
Solder paste's peculiar nature
The peculiar nature of the paste is that the metals are physically far denser than the other items.
By Tom Adams
